King Size Floating Bed Frame with Charging Station and Led Light

About this piece

A king frame, sized for a 76 x 80 in mattress.

It is built from steel frame, with steel slats and 9 legs reaching the floor, rated to 1,000 lb.

Power is built in: a Type-C port. It is an extension of the socket it plugs into rather than a circuit of its own.

The rest of the specification: the slat bearings are damped, which is where bed noise comes from and no box spring is needed.

On any frame the figures that decide how it lives are the same three: how far apart the slats sit, how much the frame carries in total, and how much support runs down the centre line rather than only at the corners.

Every bed page here states the three numbers that decide how a frame lives: slat spacing, total weight capacity and the clearance under the frame. Slat spacing matters most, because a mattress warranty usually requires slats no more than about three inches apart, and a frame that fails that quietly voids the mattress rather than the frame. The rest of the room is on bedroom, and how to choose a size is worked through in The Bed Frame Guide: Slats, Storage and Why Beds Squeak.

The same specification table appears on every page of iPormis bed frames, which is the point of publishing it: two models are only comparable when the same figures are given for both.